Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Why do PCB circuit boards need impedance
#1

 x 0 
1. Why do PCB circuit boards need impedance?
The impedance of pcb circuit board refers to the parameters of resistance and reactance, which hinder the alternating current. In the production of multilayer PCB circuit boards, impedance processing is essential. The reasons are as follows:

1. The PCB circuit (bottom of the board) should consider plugging and installing electronic components. After plugging, the conductivity and signal transmission performance should be considered. Therefore, the lower the impedance, the better, and the resistivity should be less than 1 per square centimeter. -6 or less.

2. During the production process, PCB circuit boards have to go through processes such as copper sinking, tin plating (or chemical plating, or thermal spray tin), and connector soldering. The materials used in these links must ensure that the resistivity is low to ensure The overall impedance of the circuit board is low to meet the product quality requirements, and it can operate normally.

3. The tin plating of PCB circuit boards is the most prone to problems in the production of the entire circuit board, and it is a key link that affects impedance. The biggest defect of electroless tin coating is easy discoloration (easy to be oxidized or deliquescent) and poor solderability, which can lead to difficult soldering of circuit boards, high impedance, poor electrical conductivity, or instability of overall board performance.

4. There are various signal transmissions in the conductors in the PCB circuit board. When it is necessary to increase its frequency in order to increase its transmission rate, the line itself will cause the impedance value to change due to factors such as etching, stack thickness, wire width, etc. , So that the signal is distorted and the performance of the circuit board is degraded, so it is necessary to control the impedance value within a certain range.

As the design of electronic products becomes more sophisticated and the difficulty of packaging increases, the improvement of SMT patch yield has become one of the key factors to reduce the cost of hardware manufacturing. BGA, IC, etc. in pcba manufacturing are key components, and the one-time success rate of these components is the key point during soldering. PCB manufacturing has become a priority.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)